I have another card to share with you today using the gorgeous Sweet Soiree Specialty Designer Series Paper. One more way that you can #usethatpaper I am on a mission to use up my paper instead of storing it and hoping to help you in using your stash. There are some lovely, gorgeous paper to come in the new catalogue, so you need to use this paper.
I have to admit one of the dilemmas of using the gorgeous Stampin’ Up! paper is – which side do you use?? Usually there is gorgeous prints on both sides and you don’t want to cover one to show the other side. SO, I think this fold is great as you can see both sides at once.
This card is a Collar card. I was reminded of this card when I went looking through some older blog posts. You can see that one I made -> HERE.
I liked both sides of this piece of Sweet Soiree paper so it was nice to see both of them.
To create a Collar Card
Cut your white card slightly smaller than your card base – 4mm (1/4″ ) smaller. Cut your piece of Designer Series Paper 4mm (1/4″) smaller than the white card mat.
On your piece of Designer Series Paper, at the half way point on the right hand side, which is approximately 4.8cm. Cut in from this point 5cm (2″). Fold back each section from the end of the cut to the corner of the piece of paper.
Adhere this piece on to your white card and then on to the card base. Adhere under each flap to hold them down.
Stamp the sentiment on the white section. This one is from the Waterfront set. I cut a flower from the Flourish Thinlits from Silver Foil.
Now you can see both side. 🙂
Have a great day,