A quick post for you now. I didn’t think I would get a card done for this challenge this round and it closed tonight. Apart from being busy with getting my Open House ready I just couldn’t work these colours. They are so not my colours!!
Anyway, I had some inspiration last night and had a little play today. So firstly these are the colours for the Colour Inkspiration #10
Cajun Craze Delightful Dijon Island Indigo and Smoky Slate.
What do you reckon??
Here is my card.
The background on this is created with Clear Block Stamping. I have tried this a few times over the past few years. Every time you create this technique it always works out different, even if you have used the same colours. It is an effective technique. I will explain how to below.
Firstly, on the card though. The base card is Island Indigo and the card mat is Cajun Craze. I never use this colour. I don’t even own the inkpad for it. I used the Marker. The chair from Layered Seasons Thinlits is cut from Copper Foil Sheet. Check out those clear drops! The card needed something else on the front. I was looking what to put on them and found the White Perfect Accents. I was positioning them around the card and then one of the white backs came off. It was clear! I liked that look much better so I took the backs off the other two. They look like water drops. I think I will do that more in the future. I hardly ever use those Accents as they are so stark white. (Did you know you can colour them too with Sharpies!!).
Now to create the Background.
CLEAR BLOCK STAMPING
1. Ink your Clear block. I used Block E. For this card I first inked the top half of the block with the Island Indigo ink by patting the inkpad directly on the block. I then wiped the top edge with a tissue then patted the Smoky Slate inkpad on the edge.
On the bottom half I patted on the Delightful Dijon inkpad, then wiped the bottom edge a little with a tissue to take off some ink. I then ran over the edge with the Cajun Craze marker as I don’t have the inkpad.
Using a spritzer or small spray bottle spritz the block LIGHTLY with water.
2. Leave the block on the table top facing up. I did tilt the block a little but I didn’t want it to run too much. I find when you leave the block on the table rather than turn the block on to your card it saves some runs and drips.
Place your Watercolor card on to the block and rub over the back of the card. Gently peel off the card and leave to dry.
Once dry decorate your card as you desire. This creates fun backgrounds.
Hope you will give this technique a try.
Thanks for stopping by,